This could be a DJ mixer, a mixing desk with a phono preamp or a dedicated standalone phono preamp. Step 1 - Connect your turntableĬonnecting a turntable with a phono output (eg. - Technics 1200/1210)Ĭlassic, fully analog turntables with a phono output need to be connected to a phono preamp in order to boost the volume to a sufficient level for listening and recording. In order to record audio from your turntable, or any external source, you'll need to use an audio interface, unless your turntable has a USB output. Note: Push 2 itself does not have audio inputs. This tutorial will show you the additional steps necessary to connect your turntable and set the recording level.
VIBE SOUND USB TURNTABLE DRIVER HOW TO
Until then, if you have any further questions or issues, feel free to reach out to the Audio Solutions Department, who will be happy to help.The video above shows how to record audio from vinyl using an audio interface and Push 2. Next week, we’ll show you how to listen to your turntable through a Mac, which requires a slightly different setup. Feel free to bookmark this page to refer back to it at any point. This is the nature of the beast with computers. Each time you unplug the turntable from the USB port of your computer, you may have to reset the parameters. You may adjust the computer volume as needed and listen to your records while doing other things on your computer. While playing your records, you will see movement in the recording status bar of the USB Audio CODEC. You may drop the needle on your records and begin listening. You are now set up and ready to listen to your records. Click in the box next to “Listen to this device.” A check will appear.Now that the correct playback and recording devices have been selected, you may right click on the USB Audio CODEC and select “Properties.”.If another device is selected, right click on the USB Audio CODEC and select “Set as Default Device.” Make certain nothing but the USB Audio CODEC is selected with the green check mark.Make certain the green check mark is next to the USB Audio CODEC, indicating it is selected as the default recording device.Once the computer’s internal speakers are set as the default playback device, click on the Recording tab to select the input device.If it is, right click on the computer’s internal speakers and select “Set as Default Device.” Make certain the USB CODEC is NOT selected as the default playback device with the green check mark.They are often labeled as Realtek High Definition Audio. Make certain the green check mark is next to your computer’s internal speakers, indicating they are selected as the default playback device. The Sound window will open up on the Playback tab, allowing you to select the playback device.Right click on the Speaker Icon and select “Playback devices.”.It is often located at the bottom right of the screen. Locate the Speaker Icon in the task bar on your computer.Turn on the turntable and computer and plug the turntable into the USB port on your computer.(Check past blog posts for setup information for your specific Audio-Technica turntable.) Begin by having your turntable properly set up.
Doing so will allow you to monitor the input and, if properly set to the turntable signal, pass the audio from the turntable through the computer speakers.
VIBE SOUND USB TURNTABLE DRIVER PC
Question: Can I listen to my USB turntable through my PC speakers?Īnswer: The quick answer is yes, but note that computers are designed to be “playback” devices and not necessarly “play through” devices, such as a stereo receiver, so you may need to change some settings in your computer for proper operation.